ROGTEC Magazine - Russian Oil & Gas Technologies - News, Reviews & Articles

ROGTEC Magazine - Russian Oil & Gas Technologies - News, Reviews & Articles

Smith Bits Introduces Next Generation Premium PDC Cutter

Thursday, September 8th, 2011

ONYX II PDC cutter drills 22% more footage at a higher ROP

Smith Bits today announced at the Offshore Europe 2011 Oil and Gas Conference and Exhibition the availability of its ONYX II* premium polycrystalline diamond compact (PDC) cutter. The ability of this cutter to retain a sharp edge enables it to drill more efficiently in the harshest formations.

“The ONYX II PDC cutter is driven by field performance and the result of an extensive collaboration between our engineering, manufacturing and research and development groups,” said Guy Arrington, president, Bits & Advanced Technologies, Schlumberger. “A comprehensive analysis of dull cutter conditions combined with new drilling objectives from our clients drove our development team to push the boundaries of advanced materials science and synthetic diamond manufacturing.”

The introduction of the original ONYX* cutter made a significant contribution to PDC bit performance. To continue advancement of PDC bit performance required upgraded cutter technology. The ONYX II premium cutter is synthesized using highly developed manufacturing techniques, including a proprietary two-step process that gives the new cutter superior abrasive wear and exceptional resistance to thermal degradation when compared to prior generations of PDC cutter technology. The cutter is designed to resist the spalling and chipping that shortens the life of other hard formation drill bits.

Laboratory and Field Testing

To evaluate the improved wear characteristics of the new PDC cutters, a controlled laboratory comparison was conducted on granite. The new PDC cutters showed a 20% reduction in wear flat area with minimal chipping and degradation, as measured against the earlier ONYX PDC cutters.

In Sublette County, Wyoming, a 6-in MDi516 bit equipped with the new ONYX II cutters outperformed an offset well drill bit fitted with ONYX cutters, the prior generation PDC cutter.  A notable 4,775 ft was drilled in 78.5 hours at a rate of 60.8 fph, compared to 3,900 ft drilled in 79.4 hrs at an average rate of 49.1 fph.

 

For more information on the ONYX II PDC cutter, visit www.slb.com/ONYXII.

Be Sociable, Share!

Tags: , , , , , ,

Leave a Reply

You must be logged in to post a comment.





SPONSORED ADVERTS



















rogtec
Tel: +350 2162 4000    Fax:+350 2162 4001
ROGTEC Magazine © 2009/2014 - All rights Reserved | Legal Disclaimer
Website design and development by Saul Haslam and Tictac Studio - SEO by Solar Internet Specialists in SEO Spain
ROGTEC Magazine in LinkedIn ROGTEC Magazine Feed
ROGTEC Magazine in englishROGTEC Magazine in russian